Subaru Dash Switch Type 2

3D printed precision fit bracket and switch to allow a switch install with no modification to the dash!

  • Compatible with most wire harnesses that come with a 3 pin switch
  • Pigtail has 5 wires, only 3 from the existing harness are needed (see diagram)
  • Switch is a latching ON/OFF*, rated for 30VDC/5a**

Don’t want to mess with cutting and splicing? Check out our new pre-terminated Pigtails and Ready Harnesses!

Difficulty:

$28.00

Want to install that new light bar but don’t want to drill into your dash? These switches allow you to utilize the stock blank location to install a 16mm illuminated switch!

This switch is for the bottom 4 locations on that panel, see Type IV for top two locations

Designed specifically to fit the following Subaru models:
2017+ Impreza
2018+ Crosstrek
2015+ Outback
2015+ Legacy
2019+ Ascent
2019+ Forester

 

*Switches by default are latching ON/OFF (think of a home light switch). If a momentary is needed please inquire via our Contact us page

**Switches are only rated for 30VDC at 5 amps, they are not to be part of the load bearing circuit but the trigger for the relay for that circuit

Find an error on the page? Let us know!

Additional information

Weight 2 oz
Dimensions 2 × 1 × 1 in