Subaru Dash Switch Type 1

3D printed precision fit bracket and switch to allow a switch install with no modification to the dash!

Compatible with most wire harnesses that come with a 3 pin switch
Pigtail has 5 wires, only 3 from the existing harness are needed (see diagram)
Switch is a latching ON/OFF*, rated for 30VDC/5a**

Don’t want to mess with cutting and splicing? Check out our new pre-terminated Pigtails and Ready Harnesses!

Difficulty:

*Requires cutting the back of the switch panel and drilling a small screw in

$28.00

LED Ring Color

Clear

Want to install that new light bar but don’t want to drill into your dash? These switches allow you to utilize the stock blank location to install a 16mm illuminated switch!

Designed specifically to fit the following Subaru models:

2012-2016 Impreza

2013-2017 Crosstrek

2014-2018 Forester

2010-2014 Legacy

2010-2014 Outback

2015-2019 WRX

2015-2019 STi

These switches do require some modification to the rear of the switch panel but consist of no more than cutting a small notch and drilling in a screw. If you would like more information please message me and I can provide any additional details!

*Switches by default are latching ON/OFF (think of a home light switch). If a momentary is needed please inquire via our Contact us page

**Switches are only rated for 30VDC at 5 amps, they are not to be part of the load bearing circuit but the trigger for the relay for that circuit

Find an error on the page? Let us know!

Additional information

Weight	2 oz
Dimensions	2 × 1 × 1 in